Causes the jam of the Manufactured Sand Crusher
The Manufactured Sand Crusher is suitable for hydropower, building materials, highways, urban construction and other industries. The designed output is generally 50-500 tons/hour. According to different process requirements, various types of equipment can be combined to meet different process requirements of customers. Due to the wide application of the Manufactured Sand Crusher, different small problems will occur during the use process, and the reasons for the blockage of the Manufactured Sand Crusher are analyzed in detail.
First, the Manufactured Sand Crusher feeds too fast, causing blockage.
During the feeding process of the Manufactured Sand Crusher, it is necessary to pay attention to the change of the current meter pointer at any time. If the feeding amount is too large, the current meter pointer deflection angle is large. If the rated current is exceeded, it indicates that the motor is overloaded and overloaded for a long time, which will burn the motor. In this case, the door should be immediately reduced or closed, and the way of feeding can be changed. The feeder is controlled to increase the amount of feed. There are two types of feeders: manual and automatic. Users should select the appropriate feeder according to the actual situation. Since the Manufactured Sand Crusher has high rotation speed, large load, and strong fluctuation of load, the current of the Manufactured Sand Crusher is generally controlled at about 85% of the rated current.
Second, the Manufactured Sand Crusher discharge pipe is not smooth.
If the Manufactured Sand Crusher feeds too fast, the discharge port of the discharge device will be blocked; if the conveying device is improperly matched, the output pipe will be weakened or the wind will be blocked. After the fault is detected, the air supply port should be cleared first, the unmatched conveying equipment should be changed, and the feed amount should be adjusted to make the Manufactured Sand Crusher operate normally.
Third, the Manufactured Sand Crusher hammer is broken and aged, and the moisture content of the material is too high.
The broken and severely aged hammers should be replaced regularly to maintain the good working condition of the new Manufactured Sand Crusher, and the screen should be inspected regularly. The moisture content of the crushed materials should be less than 14%, which can not only improve production efficiency, but also enable new types. The Manufactured Sand Crusher is not blocked and enhances the reliability of the new Manufactured Sand Crusher.